Instructions:
Beforehand: corrugate all paper as instructed on the Fiskars Corrugator

1. Cut out a beard and mustache out of white cardstock; sleeves, suit and hat out of red; boots and mittens from black; and nose and face from peach.
2. Out of ivory cardstock cut: one 1/4” x 2” “tassel,” one 3/8” x 3 1/2” “hat trim” and two 3/8” x7/8” “sleeve trim”
3. Drybrush the cheeks and nose with pink stencil creme by rubbing the brush in a circular motion.
4. Glue the beard overlapping the bottom edge of the face. Center and glue the mouth to the top of the beard. Dot on black eyes.
5. Shape the body into a cone. Glue the suit trim to the bottom of the cone, the mittens underlapping the sleeves and the sleeve trim centered on top. Glue the sleeves to the sides of Santa, then the present in one hand.
6. Glue the mustache pieces overlapping the mouth, then the nose centered above the mustache. Glue the face/beard to the front of the body and the hat trim slightly overlapping the top of the face and the ends of the beard at the center back.
7. Roll and glue the tassel in a tight ball and glue to the tip of the hat. Add holly leaves and berries. Add a gold thread sewn through the top of Santa’s hat for an ornanment.